http://www.amiga-hardware.com Your guide to updates at the Big Book of Amiga Hardware http://Amigahardware.mariomisic.de/raw/mainlogo.jpg http://hardware.amigafuture.de http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=150 Hardware Excerpt: Processor: EC030@40Mhz or 030@50Mhz FPU: Optional 68882. (Some versions are PGA, others are PLCC) MMU: None in EC030s, Internal in full 030s Max Ram: 32MB Ram Type: 1 x 72pin SIMM slots. An accelerator which plugs into the trapdoor slot of the A1200. An optional Fast SCSI-II controller is also available. There are only 3 jumpers on the card. There are two twp-pin jumpers for disabling the MAPROM and MMU and one three pin jumper to select the clock source for the ma... 2007-12-18 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=1785 Hardware Excerpt: The Amiga-Bremse is a device wich will allow you to slow your Amiga or to stop it. This was very useful to to get high-scores in very difficult games e.g. Amiga-Bremse connects between the 68K socket and the processor. There is a three-way switch to control the Amiga-Bremse In the middle position, your Amiga runs normal. Switch it to the left will "freeze" the Amiga just in time. Switch it to the right, acticates the potentiometer to control the Amigas speed infinitely. ... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=1415 Hardware Excerpt: The Brolock is a combined genlock, signal processor and RGB splitter. ... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=1633 Hardware Excerpt: Max Ram: 512k Ram Type: Socketed DRAM Chips RTC: No Connection: A500/+ Trapdoor Slot The expansion also includes a switch for disabling the RAM for compatibility with old games.... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=1784 Hardware Excerpt: A RAM expansion wich connects to the trapdoor slot of the A500/+ It provides the AMIGA with additional 512K of FAST RAM by using 8 DRAM chips. RAM can be enabled/disabled by a switch. ... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=1510 Hardware Excerpt: Max Ram: 2MB Ram Type: ZIP Chips RTC: Yes Connection: A500/+ Trapdoor Slot ... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=810 Hardware Excerpt: This connector uses the Amiga Joystick Port, Keyboard Port and the Parallel port. ... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=874 Hardware Excerpt: 14" Colour Monitor which supports both RGB and VGA. The monitor supports PAL and NTSC as it's capable of syncing horizontally from 15Khz to about 35Khh Monitor Pin Assignment Pin CGA (Digital) EGA (Digital) VGA (Analog) 1 GND GND R 2 GND 2nd R G (+CSync) 3 R R B 4 G G HSync (+CSync) 5 B B V... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=874 Hardware Excerpt: 14" Colour Monitor which supports both RGB and VGA. The monitor supports PAL and NTSC as it's capable of syncing horizontally from 15Khz to about 35Khh Monitor Pin Assignment Pin CGA (Digital) EGA (Digital) VGA (Analog) 1 GND GND R 2 GND 2nd R G (+CSync) 3 R R B 4 G G HSync (+CSync) 5 B B V... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=1294 Hardware Excerpt: The SoundSwitch is an audio mixer which connects to the Amiga's floppy drive connector. The Soundswitch does work with sound cards cards like AD516 or AD1012, but it is a standalone sound switcher designed primarily for the Toaster which is missing audio switching capabilities. The install software installs drivers to use under the Toaster 4.0 and higher switcher interface and also Studio16 which it installs a copy of with the switcher controls. It allows you to connect up to four audio... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=139 Hardware Excerpt: Processor: 030@25Mhz, 030@33Mhz, EC030@40Mhz or 030@50Mhz FPU: Optional 68881 or 68882 (PGA) from 20Mhz up to 60Mhz MMU: None in EC030s, Internal in full 030s. Max Ram: 128MB Ram Type: 1 x 72pin SIMM slot An accelerator which plugs into the trapdoor slot of the A1200. The board allows the configuring of the RAM speed and cycle ranges manually and supports cycle ranges 1-5 and RAM speeds of 50 - 100ns. You may need to configure this with the provided software utilities... 2007-11-11 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=661 Hardware Excerpt: Pin Function 1 GND 2 DATA 3 CLOCK 4 +5V 5 Unused ... 2007-10-29 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=1773 Hardware Excerpt: A RAM expansion wich connects to the A500/+ trapdoor slot. The card gives the Amiga 512k of more FastRAM. The GARY chip must be pulled out and reattached on the little GARY adaptor PCB to install the card. It seemes, that the device also have a RTC. Note: If you dont connect the gary adaptor then you have only 0,5MB Fastram added. If you connect the gary adaptor in wrong Direction (Like the picture) your amiga stil Boot but only with 0,5MB instead of 1,5MB Fastram. You can s... 2007-10-08 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=858 Hardware Excerpt: Multisync Monitor, RGB analogue and RGBI capable of scanning video signals from 50-60Hz. MPR II Compliant This monitor is really the CEI 1962. (CEI stands for Creative Equipment International, a major Commodore distributor in North America). It is a rebranded Electrohome 1440 monitor.... 2007-10-08 http://Amigahardware.mariomisic.de/cgi-bin/showhardware.cgi?HARDID=304 Hardware Excerpt: Full-length Zorro II card which is capable of digitizing video in realtime. Up to 7 digitizers can be installed in one machine. This card has two FBAS inputs which are software selectable. The minium requiredments to use this card is Amiga OS 1.2 and 1MBCHIP, 2MB Fast. Two versions of the software exists, one is for use with Amiga OS1.2 and 1.3 and the other is for OS 2.0 and higher. It supports digitizing in up to 720 x 625 in 32 colours, or 4096 colours with HAM mode. This card can also b... 2007-10-08